Welcome to My Mod Page!¶

Intro¶

I decided to make a website to showcase my Kobra Go and the mods I’ve performed to it.

I’ll be keeping this up to date to the best of my ability!

Recommended Order of Modifications¶

Klipper ¶

This upgrade can be performed on a stock machine, making it one of the most cost efficient upgrades.

Direct Drive ¶

Cost and time will be the biggest sinks here, as wires will need to be extended and crimped. The cost also increases as a DD extruder must be obtained.

Enclosure ¶

The highest cost and time sink. Lots of components will be needed and lots of wires extended.

Current Status¶

January '24 Setup

Software: Klipper
Mainboard: BTT SKR 3.0 + Raspi 4 4GB
Drivers: TMC2209
Stepper Motors: Stock
Hotend: Microswiss
Extruder: Orbiter 2.0
Printhead: Endli Orbiter 2.0
Cooling:

Arctic S4023-15k

Single 5015